字典仔

well i have been auto-xing and tracking my car since 00 or 01? was doing quite a bit of auto-xing but tracking is too expensive so usually once a year, twice at the most?

i was running -1.3 for front, -0.8 for rear, 0 toe front and rear 205/50 with 15x6.5 45 offset as well...no problem at all...is your car too low? lol

i am running -2.1 front, -1.4 rear, 0 front toe, 0.05 rear toe; yet i have also done a 5 lug conversion and haven't got new rims yet...was using Desmond EVO Regamaster (which make SPOON rims), can't have anything aftermarket worse than that lol....

well...i am also running 2.25" with a B18CR motor, so go figure?! that's why i had a ITR b-pipe (i think is 2") before when i had my D16...there are many diff kinda N/A, can't set them all up in the same way...

i have no problem with my suspension techique RSB (19mm, not 19" ), have been using it for at least 3 to 4 years now?! i know ppl with 21 / 22mm will crack the subframe and need sth like ASR reinforcement....

xelloss

I don't know if my car going too low..but I think it is ok...not "ricely" low i guess (could you tell from my little profile pic?)...ha ha..but when I was running the RT-615...it just rubs..but for the D motor, 205 tires maybe a bit too big and too sticky for it...the car launch pretty slow, and now the the 195 tires which responds pretty good  .

by the way, what do you drive,字典仔 ?

seems only me and you talking in this topic now..ha ha ha

[ 本帖最後由 xelloss 於 2008-5-15 21:56 編輯 ]

字典仔

your car doesn't look low in the pix...looks like there is still one to two finger's gap?

RT615 has a very square sidewall, that's probably why?!

i have a 99 Civic DX HB, it's still a very fun car to drive

xelloss

Indeed...I like EK9 too....
Are you usually cruising around in richmond?
You may have seen my car before....coz I work in richmond, so basically, i will be there everyday...

字典仔

i wish it's a real EK9, was in my friend's while i was in HK, thought it's a JDM EK9 but turned out it's a JDM EK4 with all the EK9 interior etc (even got 5 bolts and everything, the B16A was quick too)....

i go to RMD quite often (depends on work schedule but i will usually go there at least twice a week, or up to 4 times a day lol)...

might have seen your car, just ain't sure, i dun drive my car often so i dun usually get spotted lol

字典仔

原帖由 xelloss 於 2008-5-16 11:03 發表
Indeed...I like EK9 too....
Are you usually cruising around in richmond?
You may have seen my car before....coz I work in richmond, so basically, i will be there everyday...

were u at Clear One this Mon (3 to 5)? i think i saw ur car in their lot when i came out (not sure if it was that time or sun 7 to 8, i was there 3 days in a row)...

it looks good and not too low...we were the 3 subies (2 x 08, white and silver, one 01 with custom yellow) in the lot lolz

xelloss

Yeah..I was there...4-6..ha ha...

字典仔

too bad i didn't have my hatch there, i normally go to C2, at least twice there every week ;)