Board logo

標題: garage door [打印本頁]

作者: fibbi    時間: 2013-1-8 09:54     標題: garage door

呢排好黑仔。
尋晚個車房門開唔到,開咗少少就唔上唔落,急call人整,整咗不過無咗盞燈同埋個地sensor唔work,又要整過。。。sigh...
作者: yuusaku    時間: 2013-1-8 16:08

i guess the electrician  provides warranty for the job?
作者: fibbi    時間: 2013-1-8 16:12

Only if he returns my call.
作者: reyes    時間: 2013-1-8 18:49

手工好差喎, 你搵邊間, 叫D老友記唔好搵佢地
作者: fibbi    時間: 2013-1-8 23:45

無計,夜晚急call嘅都係喺報紙啲Ad隨便篤一個。真係無期望。
而家個safety sensor壞,要換個motor,又$300幾。唉。
作者: B2L2    時間: 2013-1-9 12:36

safety sensor壞, shouldn't need to change the whole motor gar..  why?
作者: satil    時間: 2013-1-9 12:55

車房門開小小上唔落,應是斷回力彈弓或拉力威也鬆了。
你第一次換了什麼?

盞燈唔著?是否燒燈泡?咁個motor有冇動?若sensor壞 (學B2L2講,咪換sensor囉,幾十蚊). 是否只係撞歪咗,或鬆咗線?

你按制開門或閉門時,motor有冇反應?有冇啲答啲答聲?

冇理由咁啱一齊壞?!!!
作者: B2L2    時間: 2013-1-9 13:24

(assume we are talking about your own house garage)

These garage doors could be easily detached from the chain (which connects to the motor).  Talk a look and you should have a red string with a pull handle.  Once you pull it down, the garage door detaches.  After this and if the rail isn't damage, you should able to move the door up/down manually.

If it happens again, you could simply pull it down manually first and don't need to call for any emergency service (usually double the charge).
作者: satil    時間: 2013-1-9 14:39

B2L2所提的方法,是MOTOR唔郁,燒了的情況是可行.

若你的車房門是細門(一架車濶),你的門有一條回力彈弓,若斷了,你要非常大力,才能由人手開門。
若你的車房門是大門(兩架車濶),你的門有兩條回力彈弓,通常斷的是一條,那時,門的回拉力只在一邊,門會斜JAM死在軌上,你是人力拉不開的.
若是拉力威也斷或鬆了,就點都不可以用人力拉開門.
作者: fibbi    時間: 2013-1-9 16:07

本帖最後由 fibbi 於 2013-1-9 16:20 編輯

Satil is right...my garage is 2 car size garage door...
最初,一條彈弓斷咗,靜返一條,嘗試過人手開不過唔得,adjust過個motor(tune up the sensitivity or power level),開到,不過落嗰時個閘出咗軌,條軌都坳咗,所以個閘唔上唔落。其實個motor無問題。
到佢換咗條彈弓,個sensor同盞燈唔work。
next day 我叫咗另一個handyman嚟整safety sensor,佢check咗之後話要換個motor,我諗佢係話個logical board唔work所以要成個motor換。

仲慘嘅係,頭一個人嚟整嗰時,整爛咗我放喺旁邊嘅summer tire,我有個架嚟鎯住啲tire,佢唔知係唔係用嚟借力,壓爛咗我個tire 中間嗰個cover仔。又唔見多二三十。。。
作者: satil    時間: 2013-1-9 17:25

本帖最後由 satil 於 2013-1-9 17:37 編輯

回復 10# fibbi

噢, jam死咗,但你又較power level,咁有機會overload.

不過一般的motor有overload protection.

我感覺第一個維修是基本換彈弓,但軌曲了可能要較過啲軌,因而影響了sensor.

第二個維修大有可能是誇大,要你換多了東西.

不過己是過去,算了.

多口問多句,你是換一條彈弓,還是兩條呢? 因第一條斷得,第二條都差不多時間了. 
亦因舊彈弓的力度因老化,會與新彈弓產生一點不平衡,門上落會有點徧力,長時間會增加磨損. 
作者: fibbi    時間: 2013-1-9 23:00

佢都算有良心同我換咗兩條。無辦法啦,呢D嘢唔識就係要俾人屈㗎啦。
作者: TurboDoe    時間: 2013-1-17 17:38

各位老友記好,我係新仔。我個garage door 又係落唔唒就彈返上去!試過reset remote, 第一次得喎!跟住度門又彈返上去!sensors 出問題?請各位老友指教。
作者: satil    時間: 2013-1-17 18:05

回復 13# TurboDoe

有很多可能性:

1.        Sensors對不準,徧差了(但未至於處於off狀態),門開始下降,軌道會有震動或輕微變位.有可能引發回彈.
2.        Motor陳舊了/軌道滑輪磨損/鑼絲鬆脫,推門下降阻力大了,引發假的overload,你試試在motor加一點下降力.
3.        你可以吓解開motor與門脫離(門頂的手拉制),用人力,拉起門,及放下門,看看是否順滑,有沒有任何位有頂住卡住感覺.
作者: TurboDoe    時間: 2013-1-17 18:46

Thx satil. 等我同屋企人試下先!
作者: TurboDoe    時間: 2013-9-25 13:06

Has anyone DIY on weatherstripping their garage doors? Bottom and sides? Where can we buy the parts from? Or is it something you have to hire professional to do?
作者: Quest    時間: 2013-9-25 17:39

typical top lifting garage door comes with a bottom seal (*vinyl) that can be replaced easily when necessary. Nobody that I'm aware of would seal the sides due to sliding surface (rub off easily).

Incl. my own, many newer installation of the sheet metal garage door types now comes with some form of foam boards cut to size and taped to the back of the garage door to keep the heat inside.

Q.
作者: TurboDoe    時間: 2013-9-25 22:21

Thx Quest. I notice another problem with my garage door. The door does not seem to close completely. I can see lights coming through the 2 sides of door, but not from the middle. So strange! Is it something wrong with the bottom weather seal or other parts of the door? Thx
作者: Quest    時間: 2013-10-1 20:38

can you try taking a pic (from inside, light off) so as to show the gap with outside lights?

Q.




歡迎光臨 溫哥華老友記討論區 (http://www.loyaukee.com/forum/) Powered by Discuz! 7.2